|
Computer with DFP output to TFT/LCD digital display with DVI input!
DFP (Digital Flat Panel) interface uses an MDR20 (Micro Delta
Ribbon) connector, which allows only digital signal transfer. It is
restricted to resolutions up to 1280 x 1024.
DVI (Digital Visual Interface) uses a DVI connector, which allows
digital or analogue signal transfer. It incorporates a second digital
link (Dual Link) which allows resolutions up to 1920 x 1080.
- MDR20 Male to DVI-D (Digital) Female
- For use with modern TFT (Thin Film Transistor)/LCD (Liquid Crystal Display) Flat Panel Displays
- Cables and adaptors are available from LINDY for the three most common video interfaces used today
- EMC (Electromagnetic Compatibility) shielded - Patent pending RF-BLOK shielded design giving:
- Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield
- Increased insulation resistance up to 25%
- No soldering requirements as interconnect design needs no 360
degree soldering - eliminating the possibility of human error and/or
cracking of the solder that causes grounding intermittence and the use
of the most hazardous waste material - soldering flux
- Tight fit of internal wires as there is no inner mould
- No requirement of ferrite cores as signal loss and degradation are
greatly reduced giving enhanced signal sharpness. Without the ferrite
cores the cable is less stressed and more flexible
- Smaller overall dimensions which allows more room behind the host or peripheral
- Increased connector and mating strength - the 4 point reinforcement
tabs on the RF-BLOK, attached to the connector, strengthens the pair as
one
Please click here for our DVI Guide.
|
